Camesa
SEARCHGO
Camesa EMC Banner 3

EMC Product Catalog

5/16” (8.18 mm) Monoconductor 1N32-S75 Corrosion Resistant

5/16” (8.18 mm) Monoconductor 1N32-S75 Corrosion Resistant

PROPERTIES:

Cable Diameter: 0.322” +0.005” – 0.002” (8.18mm + 0.13mm -0.05mm)
Minimum Sheave Diameter: 18” (46 cm)
Cable Stretch Coefficient: 1.59 ft/Kft/Klbs (1.787 m/Km/5KN)

ELECTRICAL:

Maximum Conductor Voltage: 1,500 VDC
Conductor AWG Rating: 15
Minimum Insulation Resistance: 1,500 MegaΩ/Kft @ 1000VDC (457 MegaΩ/Km @ 1000VDC)
Armor Electrical Resistance: 9.0 Ω/Kft (29.5 Ω/Km)

MECHANICAL:

Cable Breaking Strength:
Ends Fixed: 9,700 lbs (43.16 KN) Nominal
Maximum Suggested Working Tension: 4,850 lbs (21.58 KN)
Number and Size of Wires:
Inner Armor 12 x 0.0445” (1.130 mm)
Outer Armor 18 x 0.0445” (1.130 mm)
Average Wire Breaking Strength:
Inner Armor 373.4 lbs (1.66 KN)
Outer Armor 373.4 lbs (1.66 KN)
Cable TypeCore DescriptionCable Weight
 Temp RatingPlastic TypeInsulation ThicknessCopper ConstructionRes TypicalCap TypicalO.D. EachIn AirIn H2OSpec. Gravity
 °F
°C		 in
mm		in
mm		Ω/Kft
Ω/Km		pf/ft
pf/m		in
mm		lbs/Kft
Kg/Km
1N32WTZ–S75500*
260*		FEP0.0245
0.622		19x0.0142
19x0.361		3.2
10.5		45
148		0.120
3.048		201
299		166
247		N/A
500*
260*		ETFE0.0175
0.444		19x0.0142
19x0.361		3.2
10.5		45
148		0.155
3.937		201
299		166
247		N/A

* See attached specification sheet for recommended maximum temperature exposure times.

  • While insulation is rated to 1-hour exposure of 500°F, alloy armor wires may have reduced corrosion resistance at temperatures above 350°F.
  • The armor wires are made of corrosion resistant alloy steel suitable for low level H2S and CO2 environments.
  • Conductor has nickel plated wires adhering to ASTMB355 Class 10 for increased corrosion resistance. 
  • Core assembly – Copper strand consists of six wires around one center wire. Conductor resistance is measured at 68°F. Voids in the copper strand are filled with a water-blocking agent to reduce water and gas migration. 
  • SUPERSEAL, a special pressure seal agent, is applied between armor layers. 
  • The insulation temperature rating assumes a normal gradient for both temperature and weight. 
  • All values shown are nominal or typical values.


View Product Specification Sheet

© 2024 WireCo® WorldGroup. All Rights Reserved.